E1A01:

When using a transceiver that displays the carrier frequency of phone signals, which of the following displayed frequencies represents the highest frequency at which a properly adjusted USB emission will be totally within the band?

  1. The exact upper band edge
  2. 300 Hz below the upper band edge
  3. 1 kHz below the upper band edge
  4. 3 kHz below the upper band edge

E1A02:

When using a transceiver that displays the carrier frequency of phone signals, which of the following displayed frequencies represents the lowest frequency at which a properly adjusted LSB emission will be totally within the band?

  1. The exact lower band edge
  2. 300 Hz above the lower band edge
  3. 1 kHz above the lower band edge
  4. 3 kHz above the lower band edge

E1A03:

With your transceiver displaying the carrier frequency of phone signals, you hear a station calling CQ on 14.349 MHz USB. Is it legal to return the call using upper sideband on the same frequency?

  1. Yes, because you were not the station calling CQ
  2. Yes, because the displayed frequency is within the 20 meter band
  3. No, the sideband will extend beyond the band edge
  4. No, U.S. stations are not permitted to use phone emissions above 14.340 MHz

E1A04:

With your transceiver displaying the carrier frequency of phone signals, you hear a DX station calling CQ on 3.601 MHz LSB. Is it legal to return the call using lower sideband on the same frequency?

  1. Yes, because the DX station initiated the contact
  2. Yes, because the displayed frequency is within the 75 meter phone band segment
  3. No, the sideband will extend beyond the edge of the phone band segment
  4. No, U.S. stations are not permitted to use phone emissions below 3.610 MHz

E1A05:

What is the maximum power output permitted on the 60 meter band?

  1. 50 watts PEP effective radiated power relative to an isotropic radiator
  2. 50 watts PEP effective radiated power relative to a dipole
  3. 100 watts PEP effective radiated power relative to the gain of a half-wave dipole
  4. 100 watts PEP effective radiated power relative to an isotropic radiator

E1A06:

Where must the carrier frequency of a CW signal be set to comply with FCC rules for 60 meter operation?

  1. At the lowest frequency of the channel
  2. At the center frequency of the channel
  3. At the highest frequency of the channel
  4. On any frequency where the signal's sidebands are within the channel

E1A07:

Which amateur band requires transmission on specific channels rather than on a range of frequencies?

  1. 12 meter band
  2. 17 meter band
  3. 30 meter band
  4. 60 meter band

E1A08:

If a station in a message forwarding system inadvertently forwards a message that is in violation of FCC rules, who is primarily accountable for the rules violation?

  1. The control operator of the packet bulletin board station
  2. The control operator of the originating station
  3. The control operators of all the stations in the system
  4. The control operators of all the stations in the system not authenticating the source from which they accept communications

E1A09:

What is the first action you should take if your digital message forwarding station inadvertently forwards a communication that violates FCC rules?

  1. Discontinue forwarding the communication as soon as you become aware of it
  2. Notify the originating station that the communication does not comply with FCC rules
  3. Notify the nearest FCC Field Engineer's office
  4. Discontinue forwarding all messages

E1A10:

If an amateur station is installed aboard a ship or aircraft, what condition must be met before the station is operated?

  1. Its operation must be approved by the master of the ship or the pilot in command of the aircraft
  2. The amateur station operator must agree not to transmit when the main radio of the ship or aircraft is in use
  3. The amateur station must have a power supply that is completely independent of the main ship or aircraft power supply
  4. The amateur operator must have an FCC Marine or Aircraft endorsement on his or her amateur license

E1A11:

Which of the following describes authorization or licensing required when operating an amateur station aboard a U.S.-registered vessel in international waters?

  1. Any amateur license with an FCC Marine or Aircraft endorsement
  2. Any FCC-issued amateur license
  3. Only General class or higher amateur licenses
  4. An unrestricted Radiotelephone Operator Permit

E1A12:

With your transceiver displaying the carrier frequency of CW signals, you hear a DX station's CQ on 3.500 MHz. Is it legal to return the call using CW on the same frequency?

  1. Yes, the DX station initiated the contact
  2. Yes, the displayed frequency is within the 80 meter CW band segment
  3. No, one of the sidebands of the CW signal will be out of the band
  4. No, U.S. stations are not permitted to use CW emissions below 3.525 MHz

E1A13:

Who must be in physical control of the station apparatus of an amateur station aboard any vessel or craft that is documented or registered in the United States?

  1. Only a person with an FCC Marine Radio
  2. Any person holding an FCC issued amateur license or who is authorized for alien reciprocal operation
  3. Only a person named in an amateur station license grant
  4. Any person named in an amateur station license grant or a person holding an unrestricted Radiotelephone Operator Permit

E1A14:

What is the maximum bandwidth for a data emission on 60 meters?

  1. 60 Hz
  2. 170 Hz
  3. 1.5 kHz
  4. 2.8 kHz